Wait for the update process until 100% completed. When prompted, click “OK” to start the update. Note: “Preserve Configuration” is enabled by default, please disable the “preserve configuration” when updating the firmware. Then, click "update" option below the button. Uncheck the “Preserve Configuration” option. The web interface will show the current version and the new version when the upload is completed. Please wait for the several minutes when showing upload is in progress. When prompted, click “OK” to start the upload. After seeing the firmware image file chosen, click “Upload” option. Click the "update" option and click “Choose File” then choose the firmware image file. The "Properties" page is displayed the current version of BMC, it showed hexadecimal.
Enter the default "Username" and "Password" then click "OK". Note: Please allow going on the web page manually, because the web browser will determine that it is not secure. Open a web browser to login to BMC web interface. ONIE:/ # ipmitool lan set 1 defgw ipaddr 192.168.0.254 Set the BMC IP mode, IP address, Netmask, and gateway. Then, you can check the BMC version in your NOS. ( e.g., ONL) or ONIE.
After upgrade firmware success, the chassis will restart and boot to NOS automatically. (e.g., http) ONIE:/ # onie-self-update ĭiscover: Rescue mode detected.
TX packets:18 errors:0 dropped:0 overruns:0 carrier:0 RX packets:5912 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Assigned an IP address that can negotiate with TFTP or HTTP server. Reboot the chassis and enter the "Onie: Rescue " mode. Plugin the console cable into console port on the front panel of chassis. Plugin the ethernet cable to the MGMT on the front panel of chassis.